PSU SATA Power Cable Mod/Sleeving

- Add, remove, relocate Molex and SATA PSU power connectors

Last update: November 2006

Copyright © 2006 Greig Mackenzie. All rights reserved.

DISCLAIMER:
Some procedures set out in these pages MAY VOID YOUR WARRANTY. Proceed at your own risk.

The author cannot be held responsible or liable for any damages that could occur to you or your equipment while following the procedures presented on these pages. Also, the author gives ABSOLUTELY NO WARRANTY on the correctness and usability of the information provided on these pages. Please note, however, that the procedures set out on these pages have worked for the author without damages or problems, except where noted.

Please don't say I didn't warn you!

Home | Up | 1 | 2 | 3 | 4 | 5 | 6 | 7  -  Back • Next

Pictorial guide on modifying your PC power supply SATA power cable - Page 4 By Greig Mackenzie Sleeving the SATA Power Cable De-pin the modular PSU cable connector using an ATX connector de-pinning tool. Removing the inline SATA connectors Removed. Carefully cut away the existing heatshrink. Everything removed except the last SATA connector (Type 1a).

Home | Up | 1 | 2 | 3 | 4 | 5 | 6 | 7  -  Back • Next

See Also

Worklog - GAM's HTPC (Cable Management pages)

Forum discussions:
http://www.xtremesystems.org/forums/showthread.php?t=114193
http://www.xtremesystems.org/forums/showthread.php?t=114323

All trademarks and registered trademarks are the property of their respective owners.

Copyright © 2006 Greig Mackenzie. All rights reserved.