WORKLOG: GAM's HTPC - Simple Modding Make-Over

- Front panel, top blow hole, noise dampening foam, cable management, moulded fibreglass intake duct, interior paint

Last update: February 2007

Copyright © 2007 Greig Mackenzie. All rights reserved.

Overview

This is a work log illustrating how I've modified my HTPC's generic case.

Some of the mods include:

• Front panel intake with MeshX grills and moulded fibreglass duct

• Top blow hole with anti-spill cover

• Noise dampening using adhesive foam

• Cable management mods to motherboard tray

• PSU cable alterations

• Interior paint

If you are interested in doing this yourself, please read on...

DISCLAIMER:
Some procedures set out in these pages MAY VOID YOUR WARRANTY. Proceed at your own risk.

The author cannot be held responsible or liable for any damages that could occur to you or your equipment while following the procedures presented on these pages. Also, the author gives ABSOLUTELY NO WARRANTY on the correctness and usability of the information provided on these pages. Please note, however, that the procedures set out on these pages have worked for the author without damages or problems, except where noted.

Please don't say I didn't warn you!

Contents

1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 | 12 | 13 | 14 | 15 | 16  -  Next