GAM.net.au

GAM's 'Personal' Web Presence

Documenting some of the things I like, I do and I enjoy... and hopefully providing information, insight and interest for others.
A works in progress ...and always under construction ;-)

  
Home          Contact Home | Worklog | Front Panel Intake-Part 1 | Front Panel Intake-Part 2 (Duct)
PC Mods

PSU SATA Cable Mod/Sleeving

WORKLOG: GAM's HTPC - Simple Modding Make-Over

PC Front Panel Mod - Air Intake - Part 1

PC Front Panel Mod - Air Intake - Part 2 (Duct)

E6400 Core 2 Duo, Gigabyte GA-965P-DQ6, ThermalTake Big Typhoon - Part 1

E6400 Core 2 Duo, Gigabyte GA-965P-DQ6, ThermalTake Big Typhoon - Part 2

E6400 Core 2 Duo, Gigabyte GA-965P-DQ6, ThermalTake Big Typhoon - part 3 (DUCT MOD - Part 2)

Sneak Peek - Current and in-progress mods to 'Main'

Products

ThermoChill Products

!! Site Under Construction !!

GAM's HTPC - PC Front Panel Mod - Air Intake - Part 1

- Cut front slots, Fan hole, Cut and fit MeshX grills

Last update: February 2007

Copyright © 2007 Greig Mackenzie. All rights reserved.

DISCLAIMER:
Some procedures set out in these pages MAY VOID YOUR WARRANTY. Proceed at your own risk.

The author cannot be held responsible or liable for any damages that could occur to you or your equipment while following the procedures presented on these pages. Also, the author gives ABSOLUTELY NO WARRANTY on the correctness and usability of the information provided on these pages. Please note, however, that the procedures set out on these pages have worked for the author without damages or problems, except where noted.

Please don't say I didn't warn you!

Home | Up | 1 | 2 | 3 | 4 | 5  -  Back • Next
Pictorial guide on modifying your PC's front panel with a stylish MeshX front air intake - Page 3
By Greig Mackenzie

Now now, after some sanding with 240-400grit sandpaper the holes are starting to look professional.

Unfortunately I got a chip--bottom left. Bummer. A little filler and paint down the track should fix that. Apart from this, the edges are looking quite nice.

Protective plastic coating on the MeshX pieces removed and another dry fit. Schweeeeet.

Check it out on the flipside with a little finger tip balancing act. Nice.

Home | Up | 1 | 2 | 3 | 4 | 5  -  Back • Next
See Also
PC Front Panel Mod - Air Intake - Part 1
PC Front Panel Mod - Air Intake - Part 2 (Duct)
Forum Discussions
Overclockers Australia (OCAU): January 2007 Modding Competition Worklogs
Overclockers Australia (OCAU): Front Panel Intake Duct Mod (built from scratch using fibreglass) – GAM's HTPC

All trademarks and registered trademarks are the property of their respective owners.

Copyright © 2007 Greig Mackenzie. All rights reserved.

  
Home          Contact Home | Worklog | Front Panel Intake-Part 1 | Front Panel Intake-Part 2 (Duct)

© 2006-2007 GAMdesign. Website designed and maintained by GAMdesign - Webmaster. Hosted by Australian Webpage Effects (AWE).